Product Search
Search results for 'T-191'
Showing 301 - 320 of 1123 Total Results
(4) options
Location: Tamping Rods for Concrete
Tamping rods from Test Mark eliminate air voids in concrete when making slump tests, concrete cylinders or conducting concrete air entrainment test.
(5) options
Location: Yield Buckets
Steel yield buckets from Test Mark are used for determining the unit weight of aggregate for concrete.
CA-3210
Location: Water/Cement Ratio
The Cementometer is used for rapid determination of the moisture content of fresh cement and concrete, available from Test Mark Industries.
Sieve, 8" dia., #200 Mesh, Full Height, Stainless Frame, Stainless Mesh
CA-1870-08FSS
Location: Parts & Accessories
Sieve, 8" dia., #200 Mesh, Half Height, Stainless Frame, Stainless Mesh
CA-1870-08HSS
Location: Parts & Accessories
Sieve, 12" dia., #200 Mesh, Full Height, Stainless Frame, Stainless Mesh
CA-1870-12FSS
Location: Parts & Accessories
Sieve, 12" dia., #200 Mesh, Inter. Height, Stainless Frame, Stainless Mesh
CA-1870-12ISS
Location: Parts & Accessories
Sieve, 12" dia., #200 Mesh, Half Height, Stainless Frame, Stainless Mesh
CA-1870-12HSS
Location: Parts & Accessories
MA-0135
Location: Concrete Cylinder Loading Shelf, CM-2500 Series
Easier loading of 6” cylinders in CM-2500 series machines. . This optional shelf was designed to make loading and positioning of 6” (152 mm) cylinders with pad cap rings both easier and safer in a CM-2500 series machine. The shelf features a heavy-duty steel design with a plastic laminated top, so...
CA-2570-01
Location: Aggregate
Replacement abrasive charge for LA Abrasion Machine, consists of 12 hardened steel balls.
CA-4060-04
Location: Aggregate
The weighted foot assembly is lowered into the cylinder when determining the sand reading.
Compression Machine Mounting Stands
(2) options
Location: Compression Machine Mounting Stands
Compression Machine Mounting Stands are made of steel plate with the top plate and bottom flange parallel. Bolts and washers are included for securing the compression frame to the stand. Mounting stand elevates the compression machine 24.5” off the floor for the operator’s convenience & safety when...
CA-2165
Location: Clean-N-Weigh
The Clean-N-Weigh accessory offers the fastest and most efficient method of processing large, coarse aggregate samples for particle size tests.
AA-0040-A
Location: Marshall Testing
Set includes Hand Compaction Hammer, 4" Compaction Mold, Compaction Pedestal with Top Plate, Hammer Support Rod with Adjustable Guide and Compaction Mold Holder.
Feeler Gauge Stock, .001 - 12"L x 1/2"W with rounded ends
CA-0481
Location: Parts & Accessories
When used with the steel parallel bar, Test Mark's feeler gauge stock will determine the planeness of testing machine platens, cylinder cappers and other testing accessories.
(4) options
Location: Dial Thermometers
Test Mark features Dial Thermometers as part of a complete line of materials testing equipment. Easy online ordering.
CA-2700
Location: Specific Gravity Flasks
The Chapman flask from Test Mark has two bulbs for determining approximate percentage of voids and surface moisture in fine aggregates.
CA-1992
Location: Wet Washing Sieve
The stainless steel mesh cement washing sieve features nickel-plated brass frame and legs for support when drying.
CA-2980-03
Location: Aggregate
Chart has five permanent reference colors mounted in a durable protective plastic case.
