Product Search
Search results for 'D-2041'
Showing 81 - 100 of 1123 Total Results
Asphalt Dispenser, 4 Qt. (3.8 L)
AA-3000
Location: Asphalt Dispenser
Asphalt Dispenser features a round melting pot has stainless steel crucible & shell to facilitate easy clean up - from Test Mark Industries.
CA-0361-S
Location: Slump Testing
Test Mark's portable slump test sets consist of a steel slump cone, tamping rod, cast-aluminum test base with handle for easy transportation and round mouth scoop.
4" Lightweight Retainer Rings (2)
CA-0200-L
Location: Unbonded Capping (Retainers and Pad Caps)
Aluminum retainer rings are 35% lighter than steel caps to reduce fatigue. They are heat-treated and hard anodized for longer wear and durability and conform to ASTM C-1231 specifications.
CA-0600-15P
Location: Parts & Accessories
Meter o-ring gasket. Plastic Roll-A-Meter Kit replacement parts.
CA-0370
Location: Slump Testing
This cast-aluminum base provides a sturdy, level surface on which to perform slump tests. Cleats dig into the ground for firm, level support.
Location: Parts & Accessories
Bench scales from Test Mark feature a large, easy to read, backlit LCD display, full range tare function, large stainless steel pan.
(3) options
Location: Vapor Emissions Test Kit
The vapor emission test method is specified by the Floor Covering Industry as the primary measure of moisture acceptable for floor covering or coating installations.
CA-1400
Location: Lab Ovens
These gravity convection ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 0.7 cu. ft. model.
CA-1405
Location: Lab Ovens
These gravity convection ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 1.27 cu. ft. model.
CA-1410
Location: Lab Ovens
These gravity convection laboratory ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 2.0 cu. ft. model.
Stripping Tool, Aluminum Handle
CA-0240-A
Location: Stripping Tool
The durable stripping tool has a large easy-grip aluminum handle and a steel shaft. Quickly remove concrete specimens from single use plastic cylinder molds.
CA-1320
Location: Hot Plates
Test Mark's laboratory hot plate features a white ceramic surface that is acid and alkali resistant. Non-heating frame surrounds the heated plate for added protection. Easy to set analog temperature control knob with graduated scale and LED display.
CA-2670
Location: Specific Gravity Flasks
The le chatelier flask from Test Mark is used to determine the relative density of cement or sand and other fine materials.
CA-0952
Location: Test Hammer (Rebound)
The easy-to-use concrete test hammer from Test Mark gives consistent concrete strength test estimates within a range of 1,500 to 8,000 psi.
Blaine Air Permeability Apparatus
CA-2970
Location: Blaine Air Permeability
The Blaine Air Permeability Apparatus from Test Mark determines the fineness of Portland cement on terms of specific surface expressed as total surface area in square centimeters per gram of cement.
CA-0500-43
Location: Air Meter Calibrators
Aluminum Air Meter Calibrator quickly checks the accuracy of any pressure-type concrete air meter with a .25 cu. ft. base - from Test Mark Industries.
(6) options
Location: Sample Tins
Test Mark Industries supplies sample tins as part of a complete line of soil testing equipment.
Test Mark Industries supplies manuals and literature for its construction materials testing equipment products.
CA-2165
Location: Clean-N-Weigh
The Clean-N-Weigh accessory offers the fastest and most efficient method of processing large, coarse aggregate samples for particle size tests.
