Product Search
Search results for 'C-131'
Showing 201 - 220 of 1124 Total Results
CA-2590
Location: Moisture Encounter
The concrete moisture encounter from Test Mark provides an instantaneous, nondestructive moisture measurement on concrete floors.
CA-2560
Location: Sample Splitters
The adjustable sample splitter from Test Mark reduces aggregates to a suitable size and amount for gradation testing.
AA-0040
Location: Marshall Hand Compaction Hammer
The Hand Compaction Hammer set from Test Mark Industries facilitates hand compaction of 4-inch samples.
Perpendicular Verification Device
(3) options
Location: Verification Device
The Perpendicular Verification Device is used to verify the alignment of 6" x 12" and 4" x 8" concrete cylinders when using un-bonded caps, as required by ASTM C-39. The device rests on the lower platen of the compression machine, avoiding contact with your retainer rings. Simply center the...
CA-2700
Location: Specific Gravity Flasks
The Chapman flask from Test Mark has two bulbs for determining approximate percentage of voids and surface moisture in fine aggregates.
(4) options
Location: Volumetric Flask
Test Mark Industries supplies volumetric flasks as part of a complete line of materials testing equipment.
Permeability Compaction Hammer
SA-1126
Location: Permeability Compaction
Test Mark's Permeability Compaction Hammer is part of a complete line of soil testing supplies and equipment.
(3) options
Location: Stainless Steel Pans
Test Mark's rugged Stainless Steel Pans are used for mixing soils and grout samples, weighing samples, drying samples in ovens and storing/transporting materials.
Dynamic Cone Penetrometer with Auger
SA-1200
Location: Dynamic Cone Penetrometer
Test Mark's Dynamic Cone Penetrometer (DCP) uses a 15 lb. steel mass that falls 20 inches and can be used effectively in augered holes to depths of 15 to 20 feet.
(2) options
Location: Canvas Wraps
Neoprene pad inserts from Test Mark are made from a tough elastomeric material that evens out and fills irregularities in the ends of concrete cylinders to assure even distribution of test loads for consistent results.
CA-4020
Location: Proportional Caliper
The proportional caliper from Test Mark is a timesaving device used for rapid determination of percentages of flat and elongated particles in coarse aggregate fractions of .375" or larger.
CA-1400
Location: Lab Ovens
These gravity convection ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 0.7 cu. ft. model.
CA-1405
Location: Lab Ovens
These gravity convection ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 1.27 cu. ft. model.
CA-1410
Location: Lab Ovens
These gravity convection laboratory ovens are used for drying, baking, sterilizing, evaporating, heat-treating, and testing. 2.0 cu. ft. model.
(5) options
Location: Shelby Tubes
Shelby Tubes from Test mark feature a chamfered end that forms a cutting edge, and includes holes for securing tubes to a drive head.
Dynamic Cone Penetrometer only
SA-1225
Location: Dynamic Cone Penetrometer
The Dynamic Cone Penetrometer (DCP) uses a 15 lb. steel mass that falls 20" and can be used effectively in augured holes to depths of 15 to 20 feet. The DCP features a heat treated cone and zinc plated components.
Sieve, 12" dia., 2 1/2" Mesh, Half Height, Brass Frame, Stainless Mesh
CA-1610-12HS
Location: Parts & Accessories
aggregate sieve, test mark industries.
