Product Search
Search results for 'D-421'
Showing 101 - 120 of 1120 Total Results
Voluvessel, 1/20 cu ft capacity
SA-1400
Location: Voluvessel
The Voluvessel from Test Mark is a direct reading instrument that is easily used and requires no calibration. A liquid filled balloon measures hole volume after removal of soil sample.
CA-0933
Location: Specimen Curing
The curing tank immersion heater from Test Mark has an adjustable thermostat and a 1,000 watt 15 amp incolloy shielded heating element that resists rust.
(2) options
Location: 6" Cube Mold
This single cavity cube mold with base plate is used for compression testing of concrete cubes or mortar samples in the "Time of Initial" and "Final Setting" of concrete. Dimensions: 6" x 6" x 6" (152 x 152 x 152 mm).
(4) options
Location: Melting Pots
Melting posts from Test Mark rapidly and efficiently melt capping compound and perform other routine melting operations.
MA-0802
Location: Draw Rod Assembly
Safer, easier and faster changing of test platens and spacers.. The draw rod system is used to adjust the inside vertical working height of the load frame, to allow for testing samples of different heights through the use of spacers and test platens. The system is made up of a steel hand wheel with...
CA-3210
Location: Water/Cement Ratio
The Cementometer is used for rapid determination of the moisture content of fresh cement and concrete, available from Test Mark Industries.
Circulating Water Bath, Digital
AA-0065
Location: Circulating Water Bath
The circulating water bath from Test Mark is fully insulated with magnetic circulator for heating up to 12 4-inch diameter Marshall samples at a time.
(3) options
Location: Test Platens
Models available for testing 12” (305 mm) and 8” (203 mm) wide masonry units.. Both models feature large diameter spherical disk and seat assemblies, and platen bearing surface plane to .001” (.025 mm) in any 6” (152 mm) direction, through hardened to HRC 60 and plated for wear and corrosion...
SA-0200
Location: Sand Density
The Sand Cone Density Apparatus from Test Mark Industries determines the in-place density of soils.
(4) options
Location: Beam Molds
Steel Concrete Beam Molds from Test Mark are used for molding third or center point test samples.
SA-0113-05
Location: Parts & Accessories
Adapter kit for the sample ejector for 2" diameter samples.
SA-0113-06
Location: Parts & Accessories
Adapter Kit for Sample Ejector for 3" diameter samples.
(2) options
Location: Compaction Hammers
Soil Compaction Hammers from Test Mark are machined from steel and plated for rust resistance. Easy online ordering.
(3) options
Location: Wash Bottles
Test Mark Industries supplies wash bottles as part of a complete line of soil testing equipment and supplies.
CA-3150
Location: Apparatus
The Gillmore Apparatus is used to determine initial and final set times of Portland cement, masonry cement, hydraulic hydrated lime and certain mortars.
CA-2720
Location: Specific Gravity & Absorption Fine Aggregates
The conical mold and tamper from Test Mark are used to determine bulk and apparent specific gravity and absorption of fine aggregate.
CA-1430
Location: Bench Ovens
These bench ovens are used for curing, drying, and baking. Ovens feature high density insulation for reduced heat loss and efficient operation, adjustable shelves on 1 1/2" centers, gasketed doors, and scratch resistant finish. 7.0 cu. ft., 300ºF model.
(6) options
Location: Sample Tins
Test Mark Industries supplies sample tins as part of a complete line of soil testing equipment.
