Product Search
Search results for 'D1587'
Showing 61 - 80 of 1648 Total Results
Clear Calibrated Tube Assembly
CA-0600-02P
Location: Parts & Accessories
Clear calibrated tube assembly. Plastic Roll-A-Meter Kit replacement parts.
Straight-Edge 1/8" x 1 1/4" x 12" long (3 x 32 x 305 mm)
SA-0115
Location: Soils
Straightedge is for striking-off samples in molds or containers. Made of ground steel with beveled edges.
CA-2080
Location: Sieve Storage Rack
This adjustable bench rack holds all diameters of sieves up to 12" (305mm) maximum. Stainless steel rack has non-skid rubber feet, and two permanent and two adjustable rubber-coated sieve support rods.
CA-0500
Location: Air Entrainment/Pressure Meter
The air entrainment concrete pressure meter from Test Mark is part of a complete line of concrete testing equipment, available for easy online ordering.
Tamping Rod 24" long x 5/8" dia.
CA-0400
Location: Parts & Accessories
Tamping Rods from Test Mark eliminate air voids in concrete when making slump tests, concrete cylinders or conducting concrete air entrainment test. Hemispherically rounded on both ends and plated for corrosion resistance.
CA-2500
Location: Sample Splitters
The Test Mark mini sample splitter accurately divides dry materials, such as cement, powdered ores, coal, coke, sand, soils and other fine aggregates, so each half is representative of the original total sample.
(1) option
Location: Head Tank
Constant Head Tank from Test Mark features a regulating valve for flow control of water, a porous media on the bottom to filter out air bubbles and an overflow port.
SA-1000
Location: Preparation Tools
The preparation knife from Test Mark Industries is used for sample preparation and general lab work.
Compaction Hammer, 10 lb. 18" drop
SA-0130
Location: Parts & Accessories
Compaction hammers are machined from steel and plated for rust resistance. 10 lb. (4.5 kg) hammer has a drop of 18" (457mm). 5.5 lb (2.54kg) compaction hammer has a drop of 12" (305mm). Guide sleeve has four vent holes in each end of sleeve to release built-up air pressure.
(8) options
Location: Cylinder Molds - Plastic
Test Mark Industries features plastic concrete cylinder molds as part of a complete line of concrete testing equipment.
Prism Mold 1"x 1"x 10" - 1 gang
CA-2954
Location: Parts & Accessories
Gang Molds from Test Mark are designed to produce the required 10 inch gauge length prism molds. Easy and secure ordering online.
(2) options
Location: Rebar Locator
Test Mark's Rebarscope™ locates reinforcement bars in concrete and determines their depth and size.
CA-0500-28
Location: Parts & Accessories
Adjusting rod. Pressure meter replacement parts; Test Mark Industries.
CA-0500-31
Location: Parts & Accessories
Bent calibration tube. Pressure meter replacement parts; Test Mark Industries.
CA-0500-32
Location: Parts & Accessories
Inside calibration tube. Pressure meter replacement parts; Test Mark Industries.
(2) options
Location: Parts & Accessories
Test Mark hand augers feature heavy-gauge heat treated steel, zinc plated for rust resistance. Order online securely.
AA-0010
Location: Marshall Basic Compression Testing
The lower segment of Test Mark's Marshall breaking head is mounted on a base with two vertical guide rods to connect the upper and lower segments.
AA-0011
Location: Marshall Basic Compression Testing
The lower segment of the Marshall breaking head is mounted on a base with two vertical guide rods to connect the upper and lower segments - from Test Mark.
