Product Search
Search results for 'T-164'
Showing 101 - 120 of 1124 Total Results
Feeler Gauge Set, .002 to .025
CA-0485
Location: Planeness/Thickness Gauges
When used with the steel parallel bar, Test Mark's feeler gauge will determine the planeness of testing machine platens, cylinder cappers and other testing accessories.
MA-0802
Location: Draw Rod Assembly
Safer, easier and faster changing of test platens and spacers.. The draw rod system is used to adjust the inside vertical working height of the load frame, to allow for testing samples of different heights through the use of spacers and test platens. The system is made up of a steel hand wheel with...
(3) options
Location: Test Platens
Used to determine the splitting tensile strength of concrete cylinders.. The cylinder splitting head has a bearing contact area of 12” (304 mm) long by 2” (50 mm) wide, its surface is machined plane to .001” (.025 mm) and has a scribed center line of the face of the bar for easier centering of test...
SA-3500
Location: Mud Balance Testing
Mud Balances are used as standard procedure instruments for testing water and oil-base drilling fluids and oil well cements.
Fresh Concrete Field Testing Kits, 6" x 12"
CA-0510
Location: Fresh Concrete Field Testing
Fresh concrete kits contain everythiung you need for routine testing of fresh concrete testing in the field, with all items meeting ASTM standards.
Fresh Concrete Field Testing Kits, 4" x 8"
CA-0515
Location: Fresh Concrete Field Testing
Fresh concrete kit (4" x 8") contains everything you need for routine testing of fresh concrete testing in the field, with all items meeting ASTM standards.
Sand Equivalent Shaker, Spring
CA-4055
Location: Sand Equivalent
The spring-type hand shaker from Test Mark Industries is more operator-dependent than the mechanical model.
CA-0360
Location: Slump Testing
Slump cones from Test Mark Industries determine the slump of concrete in the laboratory or field. Easy and secure online ordering.
(1) option
Location: Head Tank
Constant Head Tank from Test Mark features a regulating valve for flow control of water, a porous media on the bottom to filter out air bubbles and an overflow port.
(2) options
Location: Permeameters
The Compaction Permeameter from Test Mark is used for determining permeability of clay, sand and gravel soils using the Proctor plasticity compaction method.
CA-2170
Location: 30 Minute Timer
Plug aggregate equipment into the outlet at the back of the timer. Then plug timer cord into a wall outlet and turn the knob to the desired time. Time switch will turn off equipment automatically when time expires.
SA-2013
Location: CBR Accessories
CBR Penetration Piston has 3 sq. in. (19.35cm2) base area and is about 7-1/2" (191mm) long. Designed for use in conjunction with weights to apply penetration surcharge loads.
(8) options
Location: Cylinder Molds - Plastic
Test Mark Industries features plastic concrete cylinder molds as part of a complete line of concrete testing equipment.
CA-2700
Location: Specific Gravity Flasks
The Chapman flask from Test Mark has two bulbs for determining approximate percentage of voids and surface moisture in fine aggregates.
(7) options
Location: Graduated Cylinders
Polypropylene graduated cylinders from Test Mark have a single scale with raised numerals for easy reading.
CA-0360-S
Location: Slump Testing
Test Mark's portable slump test sets consist of a steel slump cone, tamping rod, and cast-aluminum test base with handle for easy transportation.
CA-2165
Location: Clean-N-Weigh
The Clean-N-Weigh accessory offers the fastest and most efficient method of processing large, coarse aggregate samples for particle size tests.
