Product Search
Search results for 'T-164'
Showing 181 - 200 of 1124 Total Results
(4) options
Location: Test Platens
Test both cubes and cylinders. Used for testing 2” (50 mm) cubes and 3” (76 mm) diameter cylinders and cores in compression. Cube test set consists of a spherically seated platen assembly and a lower pedestal used for positioning the cube sample at the correct height for testing. The bearing block...
CA-3210
Location: Water/Cement Ratio
The Cementometer is used for rapid determination of the moisture content of fresh cement and concrete, available from Test Mark Industries.
(3) options
Location: Test Platens
Used for testing 6” (152 mm) concrete cubes and cylinders in compression. The platens bearing block is 6.5” (152 mm) square, through hardened to HRC 55 or greater, plane to .0005” (.012 mm) in any 6” (152 mm) area, has concentric circles for easier centering of cylinders and is hard nickel plated...
Dynamic Cone Penetrometer only
SA-1225
Location: Dynamic Cone Penetrometer
The Dynamic Cone Penetrometer (DCP) uses a 15 lb. steel mass that falls 20" and can be used effectively in augured holes to depths of 15 to 20 feet. The DCP features a heat treated cone and zinc plated components.
CA-4052
Location: Sand Equivalent
The mechanical motor-driven sand equivalent shaker from Test Mark is recommended for performing sand equivalent tests on a regular basis.
Constant Head Permeameter Cell
(5) options
Location: Permeameter Cell
The Constant Head Permeameter Cell from Test Mark is used to determine the coefficient of permeability by the constant head method for laminar flow of water through granular soils.
Location: Soils
Test Mark's COE Manual Compaction Hammer features a recoil mechanism in the foot assembly to reduce impact fatigue.
SA-0200
Location: Sand Density
The Sand Cone Density Apparatus from Test Mark Industries determines the in-place density of soils.
CA-0286
Location: Cube Molds
The 2-inch cube maker molding system from Test Mark uses watertight polypropylene liners which fit into a 3-gang metal mold frame.
CA-2670
Location: Specific Gravity Flasks
The le chatelier flask from Test Mark is used to determine the relative density of cement or sand and other fine materials.
CA-0236
Location: Micrometer
This concrete micrometer was designed to accurately measure the diameter of concrete cylinders with a range of 5.5 - 6.5in.
Marshall Automatic Single Compactor, 4" Stationary Mold
AA-0020
Location: Marshall Automatic Compactor
The Marshall Automatic Compactor apparatus from Test Mark compacts samples at a preset number of hammer blows and shuts off on completion.
CA-0356-L
Location: Self-Consolidating Concrete
L-Box Flowability is a method used to determine flow rates and passibility of SCC in confined spaces. Available from Test Mark Industries.
